Just a quick presentation on how to Add or Remove a Jog
What is JOG? There can be several answers for this question but if we talk in engineering, the answer might be adding bends to an entity. The entity can be a line (2d sketch or 3d sketch), a note leader or a linear dimension extension line.
Click on the pictures to read in detail on How to Add OR Remove Jogs on specific entities.
Like this:
Be the first to like this post.
1. Add your dimensions as required.
2. Right click (RMB) on the dimension extension line and go to Display Option > Jog.
3. You’ll notice two points created on the dimension extension line where you did the right click. If you can’t see that just click once on the dimension extension line.
4. Now select drag that bottom point (or point closer to dimension text, refer pic) and set the jog.
5. To remove the jog, select any of the points (as seen above) and hit delete on the keyboard.
Like this:
Be the first to like this post.
1. The process is same as seen for 2d sketch.
2. Start a new sketch or edit an existing one.
3. While in sketch mode, go to Tools > Sketch Tools > Jog
4. Select the line you want to add the jog to.
5. Now with the line selected, drag you pointer up or down or either side and draw the jog as required.
6. You can add relations/dimensions to constrain the jog.
7. To remove the jog, select the entities you to delete and press delete on the keyboard or RMB > Delete.
Like this:
Be the first to like this post.
